Flowserve Corporation : Flowserve to Present at RBC Capital Markets' 2013 Global Industrials Conference

  Flowserve Corporation : Flowserve to Present at RBC Capital Markets' 2013
                        Global Industrials Conference

DALLAS, September 3, 2013 - Flowserve Corp. (NYSE:FLS), a leading provider of
flow control products and services for the global infrastructure markets,
today announced plans to present at the RBC Capital Markets' 2013 Global
Industrials Conference in Las Vegas, Nevada, on September 10, 2013, beginning
at 3:55 p.m. Central Standard Time. Presenting at the conference for Flowserve
is Michael Taff, senior vice president, chief financial officer.

Webcast information is available on the Flowserve.com website under the
Investor Relations section and through veracast.com by following this link:
http://www.veracast.com/webcasts/rbc/industrials2013/23110295744.cfm.

Investor Contacts:
Jay Roueche, vice president, treasurer & investor relations, (972) 443-6560
Mike Mullin, director, investor relations, (972) 443-6636

Media Contact:
Amy Allen, manager, Global Communications, (972) 443-6501

About Flowserve: Flowserve Corp. is one of the world's leading providers of
fluid motion and control products and services. Operating in more than 55
countries, the company produces engineered and industrial pumps, seals and
valves as well as a range of related flow management services. More
information about Flowserve can be obtained by visiting the company's website
at www.flowserve.com.

# # #



------------------------------------------------------------------------------

This announcement is distributed by Thomson Reuters on behalf of Thomson
Reuters clients.

The owner of this announcement warrants that:
(i) the releases contained herein are protected by copyright and other
applicable laws; and
(ii) they are solely responsible for the content, accuracy and originality of
the
information contained therein.

Source: Flowserve Corporation via Thomson Reuters ONE
HUG#1727070
 
Press spacebar to pause and continue. Press esc to stop.