CRAiLAR Technologies to Hold Year-End Update Call on Thursday, March 14, at
2:00 PM PDT
VICTORIA, BC and PORTLAND, OR, March 11, 2013
VICTORIA, BC and PORTLAND, OR, March 11, 2013 /PRNewswire/ - CRAiLAR
Technologies Inc. (CRAiLAR) (TSXV: CL) (OTCBB: CRLRF) will hold a conference
call on Thursday, March 14, at 2:00 pm PDT, 5:00 pm EDT. Ken Barker, chief
executive officer and Ted Sanders, chief financial officer will host the call
and provide an update on recent corporate developments followed by a question
and answer session.
*To participate via telephone, please dial 888-481-2877, or 719-325-2329
for international callers, 5-10 minutes before the presentation start time
and use conference ID number 8477532
*To listen by webcast please join at the investor section of the CRAiLAR
If you are unable to participate during the live call, an audio replay will be
available until midnight on March 28, 2013 by dialing 877-870-5176, or
858-384-5517 for international callers, and entering pin number 8477532. A
transcript will be available approximately 24 hours after the call on
CRAiLAR's investor page.
About CRAiLAR Technologies Inc.
CRAiLAR® Technologies Inc. offers cost-effective and environmentally
sustainable natural fiber in the form of flax, hemp and other bast fibers for
use in textile, industrial, energy, medical and composite material
applications. Produced using a fraction of water and chemical inputs compared
with other natural fibers, CRAiLAR Flax is the newest natural fiber
introduction to the market in decades.The Company supplies its CRAiLAR Flax
to HanesBrands, Georgia-Pacific, Brilliant Global Knitwear, Tuscarora Yarns,
Target Corp. and Kowa Company for commercial use, and to Levi Strauss & Co.,
Cintas, Carhartt, Ashland, PVH Corp., Cotswold Industries and Lenzing for
evaluation and development.The Company was founded in 1998 as a provider of
environmentally friendly, socially responsible clothing. For more information,
SOURCE Crailar Technologies Inc.
Director, Corporate Communications
Press spacebar to pause and continue. Press esc to stop.